Open Spelter Sockets

Products Drawing

Specification (Click to the large image)

• Forged Carbon steel(5/8"∼1-1/2")
• Cast alloy steel(1-3/4"∼2-3/4")
• Normalizing and Self colored.
• Ratings are based on recommended use with 6×7, 6×19 or 6×37, IPS or XIP(EIP), XXIP(EEIP), RRL, FC or IWRC wire rope.
• One groove used on sockets 5/8"∼3/4", Sizes 7/8"∼1-1/2"use 2 grooves, Sizes 1-5/8" and larger use 3 grooves.

1. General Theory

• Never apply more force than the socket's assigned Safe Working Load(SWL/WLL) rating.
• Socket use
• 1. Anchoring system for tubes/pipes
• 2. Anchor wires of dredging material
• 3. Anchor cables of oil platforms
• 4 .Towing cables
• 5. Cables for construction, like bridges, roof constructions etc.
• Open / Closed spelter sockets are made from forged high tensile steel(JIS G 4501) and cast Alloy steel, on request special sockets can be supplied.
• Open / Closed spelter sockets are self-colored and wedge sockets are in color orange.
• Galvanized sockets can be supplied on request.

2. Before Using

• Must be take a provide personal protection equipment. (Such as footwear, gloves, Crash helmet, etc.)
• Working place always shall be the lighting.
• Shall be work, before remove dangerous article in the surroundings.
• Seizing : Seize the wire rope or strand as shown using soft annealed iron wire.

* =5D or 50D (d=diameter of the largest wire) Whichever is greater.
Strand	Wire Rope

• Brooming is done after wire rope cables has been placed into the socket.
• When using resins always follow eactly the directions of use on the packing.
• Socketing only to executed by specialists of slings shops.

3. Using

• Never make a wrong application of the rule. (Overloading & Improper use can result in injury.) (See Figure 3.)
• Over the 20kg weight products' using, must be use an appliance tool. (Forklift, crane, hoist, etc.)
• Where apply, must locate outside the danger zones. (A falling load may cause serious injury or death.)
• Never repair, alter, rework, or reshape a hook by welding, heating, burning, bending or grinding.

4. Important

• Should extreme circumstances or shock loading be applicable, this must be well taken into account on selecting the product to be used.